Hmmm IIRC the torquey we got only does up to 200nm... If it were me I'd use that then swap to 'big breaky' and put a bit more on it!Originally Posted by CaptainGoSlow
LOL! The trailing arm is looking like it'll be fun. Going to order new bolts and nuts tomorrow. Got to take off the collar nut from the wheel hub, which from Bentley is tighten to a worryingly low torque of 250Nm. Can't remember if the torque wrench even goes up to that? If not, then may have to consider a new one. Think you may see another thread popping up shortly about this one!
On the bright side you only have that big one to remove in place of my six annoying little hex bolts! *Should* be a piece of p*ss mate.
Reply With Quote