I assume you mean the beer cans. There is a lot in archives here in the 5 series forum, or here
http://www.bimmerboard.com/forums/e3...+can&forum=e32
Hi,
both of my rear rubber mounting (part #2 in diagram below) for rear axle carrier are busted. I need to replace them.
Appreciate for comment on replacing them:
- is it DIY? (I can change absorber on my own.. so i'm a bit DIYer)...
- other than the rubber mounting, what else critical to replace at the same time?
- Can i do this alone?
- how to push out the old rubber?
- and how to push in the new rubber mounting?
thanks in advance,
rahman
Rahman in Kuala Lumpur,
1988 520i M20B20
1988 730i M30B30
1982 323/6 M20B23
1980 316
1984 GPZ550
I assume you mean the beer cans. There is a lot in archives here in the 5 series forum, or here
http://www.bimmerboard.com/forums/e3...+can&forum=e32
Hi Shogun,Originally Posted by shogun
Thanks for the link. Yup, it's the beercan. But after looking at some of the postings, i think will change the pitman arm bushes as well...
regards,
Rahman in Kuala Lumpur,
1988 520i M20B20
1988 730i M30B30
1982 323/6 M20B23
1980 316
1984 GPZ550