i'm trying to drain the god-forsaken coolant out of my m60. welll the radiator drain plug is easy as pie to get off, but bently says theres an engine block plug under cyclinder 6. (thats the drivers side right?) and i assume becuase the thermostat is closed just draining the radiator won't get it all out, correct? soo how the fdsasdlkh do i get the engine block drain plug off? its impossible. i can't fit a rachet, with any number of u-joints or extensions in there, i can't turn any type of tool in the small space, and the exhaust is so close i actually can't even fit the rachet over the bolt. maybe if i drive all the way back *across* town to sears i can find some $60 contraption i'll never use again to do this. if anyone has photos so i can check that i'm actually doing the right screw it'd be awesome. to get anyhting normal over the bolt i'd have to drop the front x-member, unbolt the exhaust manifolds, jack up the engine and remove the engine mounts (i think they're in the way too) and take off both AT cooler lines (they're in the way to) and while i'm here, would anyone trade their 6cyl for my 8? grrr