New suspension install - still help needed

[BigKriss]

Got h&r springs matched with koni adustables replacing my stock 210,000 km setup. Sits lower for a more agressive look. This car loves corners. Not much room from underneath the car to the ground. The ride is firmer but still absorbs bumps well. Got the front on fully soft and don't know about the rears. It greatly improves the handling of the car. I love it.

I'm hearing a "clunking" sound in the front suspension when going over bumps in the road at lower speeds (about 30 kms), this was happening before the new suspension setup.

Ive had the bushes replaced in the thrust arms to no avail. Any help guys?

[winfred]

with the work that's listed to have been done, id guess the sway bar links are it

[632 Regal]

id guess that the strut collar nuts arent tightened enough, how tight did you spin them?

[winfred]

he said it did it before and after suspension or i would of brought up the collars

id guess that the strut collar nuts arent tightened enough, how tight did you spin them?

[bimmerd00d]

lack of oil in the strut casing.

[BigKriss]

thanks for the info.. I'll look into it winfred

[shogun]

these items and it works fine now. No more 'clonk'

read here

[632 Regal]

ok, re-reading his stuff I might have an idea. You say you had new thrust arm bushings pressed in, how are the balljoint ends? If they are loose thats a problem, what condition is the control arms and bushings in?