Not sure about your car... but it seems like alignment problem... so I would loosen up the radiator and try to get it in before you finally place the radiator into position.
Like the title says...
I took out the radiator out and changed it out (without removing the fan....which was sooo much less work and totally manageable) but I didn't know that I had to pull the tranny cooling lines to remove the radiator.
I ended up taking them off with minimal loss of tranny fluid but now there is NO WAY in Gods name that they are going in....Any advice?
The cooling lines are not the ones built into the radiator rather a separate mini radiator attached to the front of the radiator.
Thanks guys!
Not sure about your car... but it seems like alignment problem... so I would loosen up the radiator and try to get it in before you finally place the radiator into position.
The radiator is already mounted but the cooling hoses are flexible enough that they can be somewhat manipulated. It just seems that they just wont go into their holes for some reason!
I would appreciate more than one feedback as I need to get this beast back on the road.
Thanks guys!
check the threads, might be a different size? Never heard of such mishap.
95 E34 530I V2.37
===========
Those who make peaceful revolution impossible will make violent revolution inevitable.
John F. Kennedy
That is the thing...they are not threaded.
http://www.turnermotorsport.com/imag...EM_part_sm.jpg
Sorry for the horrible pic but this is all I could find.
This thing connects to the front of the radiator. In the bottom left where there are two hole. That is the in and out of the tranny cooling lines. They seem to push ones as they are smooth. But for some reason I am unable to push them in...I am going to try to give it a love tap in the morning but I would appreciate any other ideas.
p.s. I will look for a better picture
WTH....realoem.com not longer has the E34....ARRRGGG
THIS IS BS!!! >=(
K found a picture
Transmission Fluid Cooling Lines - Halp - Bimmerforums - The Ultimate BMW Forum
in the bottom picture hose 5 and 6 I am unable to push them into where 4 goes.
I have no idea why...they were a little snug getting off...but I dont understand why they wont go back in