yes, that is one of the master pieces from Bill R.
This was a fun job, http://www.lehrmangroup.com/rickard/seatswitch.html
I had been putting it off because it was the passenger switch that was not working. The seat would not go back, every other direction was working fine. Only short legged passengers could ride in front. Thanks for the write up Bill R.
The seat now goes back! I do like the "Don Gale" colors.....
M20 525/7 Bore: 84.50mm Stroke 81mm CR 8.5:1, blue printed/dyno & custom chip. Boost @ 6.5psi ~246hp @ 5300rpm / torque @ 269ftlbs. @ 4250rpm
I just thought this fix was one of the easier one's out there, provided you have a nice clean work space and you don't loose any of the springs or the little tiny dumbbells. I say this because one of the little springs bounce off the workbench and I thought it was gone. I did find it, but if I hadn't not sure about replacement springs. I guess that would of involved a junk yard u-pull-it visit.
M20 525/7 Bore: 84.50mm Stroke 81mm CR 8.5:1, blue printed/dyno & custom chip. Boost @ 6.5psi ~246hp @ 5300rpm / torque @ 269ftlbs. @ 4250rpm