Well here it is Sunday evening and i'm reflecting on my weekend. It started with me spending a few hours Saturday pulling the 6 speed manual, driveshaft and diff. from my parts car. I also found that the sway bars where by far larger than what was on my car so I took them also. I got up fairly early today and got the car raised up and doing the same thing again, My brother shows up about 12:00 and we pull the 5 speed manual out and up goes the 6 speed. This is when we found that the clutch is a bit different. The parts car had just had a clutch job on it (1600.00 by the PO) so I jack up the parts car and pull the entire clutch also. After putting and pulling the 6 speed 4 times we found that somebody had buggered up one of the guide pin holes. It wasnt to bad but there was no way this transmission was going to slid up with the issue. A couple of passes with a dremal and all was good. It took a bit longer than expected but I guess that is to be expected lol. I took the car for a test drive and OMG I love this and the new diff is limit slip also. I'm very tired but boy what a weekend. I just wanted to share as I cant wait to get her out on the highway.
Johan