Ok,

I tried searching to no avail. Here is the problem I have.

I can get hot air blowing through the vents and the defrsoter vents, but cannot get any to blow out of the floor heat vents.

Looking at Bentley, I found it less than helpful. It merely says - there may be up to 10 stepper motors and very generally describes how to replace them. It does not show locations nor does it have any electrical etsting procedures suggested.

1994 525it US model.

Do i need to just rip the dash out and start guessing or does anyone have any suggestions?

I figure it has to be the flaps in some manner - either the controls are not working or the motors.

Anyone?

-Dave