![Quote](images/misc/quote_icon.png)
Originally Posted by
robert g
Ok I figured it out.... This how I bleed the cooling system....
1 make sure the engine is cold... Well this is how I did it..
2 pour coolant in the radiator till it is full...
3 I had purchased the vacuum/bleeder tool for the slave cylinder but it didn't work for that.. I connected it to the bleeder valve on the radiator.
4 I vacuumed out the coolant from the bleeder valve. It took about 2 min of just air and than I got 3 containers full of coolant. Make sure that the radiator cap is on.
5 I than started the car with radiator cap on and bleeder valve off.
6 It took about 2 to 3 minutes to start getting hot air out of the vents. That was cool... well I mean hot... HaHa...
7 the car ran for 10 min and only getting to 1/4 mark. I than tighten the bleeder valve back on and drove the car till it got 1/2 mark.. And that my friends was it.......