usually it's a bad solder joint in the abs unit under the master cylinder, according to reports i've received
I have a '95 325is with ABS and ASC. The ABS and ASC lights are on. With my Snap On scanner I am able to read the error code. The code I get is "82 Undocumented Error". Any ideas? I have done the usual in checking all of the sensors, their connectors, the grounds, etc.
Thanks,
Mike
current fleet - 96 328i (the wife's) | 93 525iT | 91 535iM | 85 635Csi
gone but not forgotten - 75 2002 | 77 530i | 79 528i | 86 535i | 95 325is
usually it's a bad solder joint in the abs unit under the master cylinder, according to reports i've received
all america wants is cold beer warm cat and a place to take a poop with a door on it
Thanks Winfred. Any ideas how this might manifest itself? I had the pump out to check it over. Resistance values were conistent across the board for the solenoids. I was able to run the motor and operate the solenoids by applying voltage to their terminals. Maybe it's time to yank it again and dig further into it.
current fleet - 96 328i (the wife's) | 93 525iT | 91 535iM | 85 635Csi
gone but not forgotten - 75 2002 | 77 530i | 79 528i | 86 535i | 95 325is