GO FISHING, use SLABSAUCE Fishing Attractant
Results 1 to 2 of 2

Thread: Trans program after Intake Gasket R&R

  1. 05-13-2007, 01:29 PM #1
    Evan
    Evan is offline Grand Master
    Join Date
    May 2004
    Location
    Maryland
    Posts
    1,027

    Default Trans program after Intake Gasket R&R

    I replaced my intake gaskets, pcv, water pump, etc etc... on my initial startup I received the infamous trans program message and my tranny stays in limp mode.

    Also, the Traction Control light stays on... what could I have done to cause this?
    1994 540ia|Oxford Green Metallic|Lemforder|KYB in H&R|18" OE Staggered M-Parallel with Pirelli P-Zero
    Reply With Quote Reply With Quote
  2. 05-13-2007, 04:47 PM #2
    Evan
    Evan is offline Grand Master
    Join Date
    May 2004
    Location
    Maryland
    Posts
    1,027

    Default

    Solved:

    by switching two cables --I crossed the cables going into the throttle body... switched them around and problem went away.
    1994 540ia|Oxford Green Metallic|Lemforder|KYB in H&R|18" OE Staggered M-Parallel with Pirelli P-Zero
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Intake gasket question.
    By bbig119 in forum 5 Series BMW
    Replies: 6
    Last Post: 12-25-2006, 01:38 PM
  2. Trans Program!!!
    By saj3n in forum 5 Series BMW
    Replies: 117
    Last Post: 12-03-2006, 01:09 AM
  3. M60 Intake gasket placement
    By Alpinewhite in forum 5 Series BMW
    Replies: 2
    Last Post: 11-19-2006, 08:59 PM
  4. Trans Program
    By acidmale69 in forum 5 Series BMW
    Replies: 3
    Last Post: 05-13-2006, 05:38 AM
  5. Trans Program 54
    By monchichi in forum 5 Series BMW
    Replies: 2
    Last Post: 04-15-2004, 12:48 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules