Hey guys, my Cruise Control wire had a bad bushing where it connects to the throttle assembly, and was holding the throttle down (stuck) even when I'd let off the gas.

Managed to disconnect it up top and keep it from happening, look in the ETK, and you can't buy the bushing... you buy a whole new cable assembly. Fine.

Ordered the cable, comes with all the stuff, go to swap em out... and the stock one is kinda "stuck" inside the cruise control motor. I can't figure out how to disconnect the thing, and I can only get a good look at the new one, since the old one is kinda in an awkward place.

Anyone replaced the cable before? Tips/tricks??

Thanks!

-Tim