Come on....I know somebody can help me a little here. At least tell me of I should be getting a snug fit with the 9005 bulbs in the lowbeam socket.
I had to replace a bulb and opted to do the upgrade to 9005 so I replaced both bulbs today after the quick and easy modification. When I went to remove the old bulbs, the copper ring that helps hold the bulbs in on the light fixture came out. I replaced it when the new bulbs went in but the rings aren't tight against the fixture and consequently, the bulbs are also not held in as tight as I thought it should.
Looking at RealOEM, I can't see this copper ring or a part number for it.
Any comments or suggestions?
Thanks,
Bryan
'94 540I 6spd/205000 miles
Come on....I know somebody can help me a little here. At least tell me of I should be getting a snug fit with the 9005 bulbs in the lowbeam socket.
'94 540I 6spd/205000 miles
A picture would help. I've been removed from OEM lights for too long to remember.
Did that. So I have both the old o-ring from the 9006 and the new smaller o-ring that was on the new 9005.Originally Posted by attack eagle
Qube, I'll try to get a picture ASAP, been a bit hectic lately.
Thanks for replies.
'94 540I 6spd/205000 miles