should work unless the gasket is very hard and stuck, then I would use a sharp chisel working it very carefully. When done clean the surface well with some harsh chemical to remove any other residual gasket and oil.
MAKE SURE THE BOLT HOLES ARE SPARKLY CLEAN AND NO OIL OR ANTIFREEZE!!!
Originally Posted by
BigKriss
Also how do I prepare the block. I was going to get the gasket debris off with a razor, will this be good enough?
Last edited by 632 Regal; 04-03-2007 at 09:55 PM.
Reason: aixelsid
95 E34 530I V2.37
===========
Those who make peaceful revolution impossible will make violent revolution inevitable.
John F. Kennedy
Green Beret Special Ops
Posting Permissions
Reply With Quote