Speaking of even more clutches...eek

[Fetch]

I'm really worried about how late my clutch engages, in between the few inches of dead space when you first push the clutch down & from the floor up, there is at the most 1 inch of movement in the pedal that I get grab.

I'm not going to be able to do the job myself due to various circumstances (The only time I have free time & a garage to work in is when I am working full time), so I am trying to find out when I should have it done.

I can take a picture of inside the viewing window if that would help somebody really give me a good estimate on how much I've got left on this clutch.

Anybody near northern Illinois want to drive my car & tell me how much is left on the clutch? lol

[filip00]

well, i drive a 525i 24v, late '90., and i had to reinstall clutch, because it was already wasted when i bought the car. i bought the SACHS kit, and the self leveling clutch works perfect. it grabs when the pedal is about ond one third of the way to be released. also, when depressing, it starts to go hard when pressed 1 inch.


now one question, so i don't open a new thread immediatelly.....that was all perfect, but like a week ago, i felt the play expanded from one inch to at least 3 inches! what's the problem? driving is fine, no problem with where it gets the clutch or how it drives. does it have anything to do with cold weather?

[Fetch]

bump....anybody.....?

[nizmainiac]

is it slipping yet?

[Fetch]

is it slipping yet?

not at all as of this morning

[nizmainiac]

the reason i ask if its slipping is because its quite hard to tell from a side veiw just how much the friction plate has left on it, i say this because earlier this year i had to do an engine change on my 525, i knew the clutch plate on the original engine was good, and when i pulled the motor out and had it side by side with the one that was going in, in its place, the thickness of the clutch plates looked to be the same, but when i pulled it apart not only was it stuck to the flywheel but the friction material was pretty much on the rivets,good job i had a look really, the original plate had much more left on it, so you can never tell

[Qube]

Take that picture

[Fetch]

Take that picture

I'll try that

[Fetch]

Ok, here are the pictures......They are bad pictures due to the whole under the car thing, I can't make anything of them either way...

Click here for a bunch of them, see what you can make out

Here are two of the pictures:

[Fetch]

Is the sliver of different looking metal the actual clutch friction material?