GO FISHING, use SLABSAUCE Fishing Attractant
Results 1 to 8 of 8

Thread: Fixing my intermittent Blower

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Join Date
    May 2006
    Location
    NH
    Posts
    2,062

    Default Fixing my intermittent Blower

    So i've now noticed twice my heater A/C blower stops suddenly lately when i shut my drivers door as i am getting in.Its running>shut the door,ok slam it, > the blower cuts out. Can this tell anyone weather i need to replace the console controls, the blower motor or the black box(I don't have the sword!).
    Last edited by Jehu; 11-24-2006 at 09:02 PM.
    1995 540i Manual build 1/95

  2. #2
    Join Date
    Jun 2006
    Location
    california
    Posts
    20

    Default

    Had a similar problem,,with my 92 525i,after disassembly, it turned out to be the brushes in the blower motor,,,worn badly. Apparently sometimes making contact and sometimes not...Try disassembling and checking the motor...

  3. #3
    Join Date
    Apr 2006
    Location
    Long Island, NY
    Posts
    352

    Default

    You won't have a sword, but it could be the resistor pack. I had intermittant blower problems which occurred when I tried to use any other blower speeds other than 4. I would get air(cold air since it was summer) for a short while then it would cut out for a couple minutes then come back again. Replacing this resistor pack fixed my problem. Sounds like your symptoms are a little different though.
    '94 540I 6spd/205000 miles

  4. #4
    Join Date
    Jan 2004
    Location
    Albuquerque, NM
    Posts
    953

    Default

    Quote Originally Posted by bbig119
    You won't have a sword, but it could be the resistor pack. I had intermittant blower problems which occurred when I tried to use any other blower speeds other than 4. I would get air(cold air since it was summer) for a short while then it would cut out for a couple minutes then come back again. Replacing this resistor pack fixed my problem. Sounds like your symptoms are a little different though.
    Forgive my ignorance since mine has a sword, but do resistor packs have an analogous connector portion that could be susceptible to bad/cold solder joints like swords sometimes suffer from? If so, then it would be a simple DIY to reflow the solder -- worth a try.
    gale
    92 735i 5-spd, turbo project finally underway!


  5. #5
    Join Date
    May 2006
    Location
    NH
    Posts
    2,062

    Default

    I am just hoping i can begin with replacing the right part and not end up replacing everything. I have an eversion to buying used parts of this nature as if mine have failed i have every reason to expect a similarly aged replacement has every bit as much of a chance of failing .
    1995 540i Manual build 1/95

  6. #6
    Join Date
    May 2006
    Location
    NH
    Posts
    2,062

    Default

    Is this resistor pack the black box down near where the sword in other models is fitted,where i pulled it out to changed my microfilter or is it the Blue unit that resembles a relay under the driver's dash above the gas pedal?
    1995 540i Manual build 1/95

  7. #7
    Join Date
    Jan 2004
    Location
    Albuquerque, NM
    Posts
    953

    Default

    Quote Originally Posted by Jehu
    Is this resistor pack the black box down near where the sword in other models is fitted,where i pulled it out to changed my microfilter or is it the Blue unit that resembles a relay under the driver's dash above the gas pedal?

    I'm guessing it's the black one. Have you checked Bruno's page?

    http://www.bmwe34.net/e34main/mainte...ical/sword.htm
    gale
    92 735i 5-spd, turbo project finally underway!


  8. #8
    Join Date
    May 2006
    Location
    NH
    Posts
    2,062

    Default

    Yah,I've checked the site.I know where that black control unit is ,i encountered it when changing the micro filter.The intermittent problem was present before i did that so i don't think i disturbed the connection there.I just thought mentioning that the blower shut off when i slammed my drivers door shut would ring a bell with someone and pinpoint the culprit.Obviously wishful thinking..
    1995 540i Manual build 1/95

Similar Threads

  1. How would I know - IT needs fixing !!
    By Cressidom in forum 5 Series BMW
    Replies: 15
    Last Post: 09-16-2006, 11:05 PM
  2. Intermittent Fan Blower
    By clhorton in forum 5 Series BMW
    Replies: 3
    Last Post: 06-14-2006, 02:39 PM
  3. Fixing rad....?
    By Jake Casson in forum 5 Series BMW
    Replies: 2
    Last Post: 06-12-2006, 04:41 AM
  4. Intermittent non starter
    By Unregistered in forum 3 Series BMW
    Replies: 1
    Last Post: 06-06-2004, 12:22 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •