Quote Originally Posted by Jon K
Ok - Ive removed all that crap before so I am going to go that route. Jacking up the motor/dropping subframe just sounds... not fun.

I have a full tube of Permatex Hi Temp RTV Silicone Red "GASKET MAKER" I checked their website, doesn't mention sensor safe. Hrm, think its good to use?

Also - should I let the RTV, should I use it, fully cure (who know show long that'd take?!) or is it ok to drive maybe ~ 1 hr or so after installation.
It'll say on the new tube of Permatex Jon. I usually wait overnite (4-hours min.) .
As far as going with out it.....I would definatly use some at LEAST at the points Bill R has indicated .
Your car will be seeing elevated engine bay temps and the temp of the oil will be higher than norn too.....the thin viscocity of oil will find a leak.......just drop at a time makes a mess in NO time when parked on a nice clean floor.
SEAL IT....top and bottom thinly, your choice.
.........Vinny