Need Help On Wiring !!! Asap !!!!

[wheelerdealer]

New to BMW's and just getting this project almost done. There is a single wire that is brown with a green stripe that runs infront of the timing belt cover. It has a 2 prong plug with a single wire. I can not figure out where this goes?

ALSO the wire the goes around the spark plug wire and has a 3 prong plug where does that plug into?

my car is a 1989 525i.

[wheelerdealer]

to the front

[Rustam]

New to BMW's and just getting this project almost done. There is a single wire that is brown with a green stripe that runs infront of the timing belt cover. It has a 2 prong plug with a single wire. I can not figure out where this goes?

ALSO the wire the goes around the spark plug wire and has a 3 prong plug where does that plug into?

my car is a 1989 525i.

I am guessing you are talking about crankshaft position sensor and cylinder 6 sensor. Both plugs go side by side into the main harness plastic enclosure by the fuel pressure regulator but on the passenger's side. In correct position plug wires run down.

[wheelerdealer]

http://img81.imageshack.us/my.php?image=dfd0025jl.jpg

Here are pictures of what I need some help on. thanks

[Rustam]

I apologize...
For some reason I imagined that you had 535 not 525.

[DaveVoorhis]

The spark sensor lead plugs into the engine harness that is suspended under the intake manifold. It plugs underneath, so it's hard to see where it goes. Position a mirror near the bottom of the head oil return pipe and aim it to look up. Then you should see the jack.

http://img81.imageshack.us/my.php?image=dfd0025jl.jpg

What does the other end of it connect to? Is the oil pressure sensor (roughly under the right side engine mount) lead connected? Is the A/C compressor lead connected?

[winfred]

the single wire goes to the oil pressure switch behind the compressor, the inductive pick up from the #6 plug wire plugs in right next to the crank position sensor's wire under the intake, neither will keep it from running

[winfred]

the ac lead comes off the frame and has a 3 wire plug usually with a single round pin wire and sometimes a jumper wire in the plug

Is the A/C compressor lead connected?

[DaveVoorhis]

the ac lead comes off the frame and has a 3 wire plug usually with a single round pin wire and sometimes a jumper wire in the plug

Cool. I had no idea. Here in the UK, I've only seen one M20 with A/C, and it had been very amateurishly (mostly) deleted. The compressor was still there, but all associated wiring and piping was removed.

[wheelerdealer]

I am shooting to start my car for the first time tonight if I get these wires figured out. I even bought a bently book for my car and that was the biggest waste of $25 I have spent so far on my car. It dont show nothing.