Quote Originally Posted by Jeff N.
How much change are you seeing? Are we talking slight changes in the thousands of an inch range or more significant changes? Are the gap changes consistent across all intake and exhaust valves or different?

Sounds a bit like a cam positioning issue...but...I'm not really sure until you share more.

thx
I haven't had a chance to check the change in every single one since the re-adjustment. But when I did the re-adjustment 10 out of 12 valves were out of spec (going by Bentley's Spec of .012 cold). They all seemed to follow the same trend...intake loose, exhaust tight but I didn't actually check at that point how far off, though I should of.

I just ran out there and I was able to slide a .015 underneath the first intake valve. Have to go eat dinner out and will try and check all of them again and see how far each one is off.