8mm fastening bolt. There are six fasteners for the housing, that is one of the two loooong ones. Not a vanos user, so can't answer the second part.
Dave M
2 Grand Master
8mm fastening bolt. There are six fasteners for the housing, that is one of the two loooong ones. Not a vanos user, so can't answer the second part.
Dave M
10/90 Build 525im, 630,000+km, Eibach/Sachs, Engine Rebuild
*RIP Oskar the DOG*
Grand Master
I'll agree with Dave because of its immediate proximity to the lower oil cannister housing.
Green Beret Special Ops
Tie an oil feed to the blower to the oil pressure sensor, dont know where to run it back though.
95 E34 530I V2.37
===========
Those who make peaceful revolution impossible will make violent revolution inevitable.
John F. Kennedy
5-10 Grand Master
Originally Posted by 632 Regal
Running back goes to the oil pan.
Winfred, I see the area you're talking about for vanos line. Could I drill and tap there since I don't have that by default?
5-10 Grand Master
i don't see why not just besure where you are drilling before you destroy a housing by drilling into a bad area as i've not tryed this and don't know if they change internally, disclamer disclamer disclamer blah blah blah blah....
all america wants is cold beer warm cat and a place to take a poop with a door on it
Posting Permissions
Reply With Quote
