BIG Problem...
The Plastic Bleeder screw on the radiator expansion tank broke in half today. Any tips on getting the other half out? I could drive around spewing antifreeze all over the place, but at $22/gal. I would rather not. As always all advice is much appreciated.
Green Beret Special Ops
Winfred uses a hot screwdriver to melt a slot in it, someone else used a different technique that I dont remember. Maybe a search on broken bleeder screw?
95 E34 530I V2.37
===========
Those who make peaceful revolution impossible will make violent revolution inevitable.
John F. Kennedy
5-10 Grand Master
heat the tip of a screwdriver and melt it into the screw then back it out, just don't melt into the radiator and screw up the threads
all america wants is cold beer warm cat and a place to take a poop with a door on it
Green Beret Special Ops
I knew I was close.
95 E34 530I V2.37
===========
Those who make peaceful revolution impossible will make violent revolution inevitable.
John F. Kennedy
Thank you...
Thank you very much. Got the broken bleeder screw out this morning. Thanks for all of the advice. You guys make owning one of these cars a lot easier. Thanks again
5-10 Grand Master
A lot of people forget stuff like that. My buddy stripped the hex head off of his HID ballast... i dremeled a slit in it and unscrewed it. He thought i should get an award or something.
Posting Permissions
Reply With Quote