I read the problems below on trans noises when the pedal is depressed. I've had this noise for a while and now it's louder than ever, sqealing. The car is also chugging when clutch is halfway engaged but grips well when fully disengaged. Last clutch was at about 180k miles. I'm now at 348K miles. Indy did last clutch job. I've recently installed brand new driveshaft, not rebuilt, and a new axle from BMA within the last 2-3 months. I'm ready to tackle the clutch replacement. Does anyone have a good write-up on this procedure? Do I need any special sockets/tools? I've already order a new Sach's clutch kit, pivot arm, and pivot pin. I've also got new shift bushings to install when I do the job.
Thanks Guys,
rommel
90 535i 5spd