Hubcentric Ring Question

[632 Regal]

The rings look right but im not sure without seeing them on the car and against the wheel, you might want plastic ones anyways cause the aluminum sometimes welds itself to the wheels.

The 1 finger width is about right.

[E34 530]

I was told to get aluminum ones because the plastic ones become brittle and crack.

[632 Regal]

choose your poisen.

Id rather get a few sets and install fresh vs chiseling the old ring off my wheels.

[E34 530]

What kind do you have??? I would like to get new rings before the tires come to hopefully solve the problem for good. Do you have any problems with your rims? What size are your tires?? -Thanks

[liquidtiger720]

What kind do you have??? I would like to get new rings before the tires come to hopefully solve the problem for good. Do you have any problems with your rims? What size are your tires?? -Thanks

I myself have plastic ones.

[E34 530]

Liquidtiger, I know you originally had a lot of problems with rubbing and whatnot. Where did you get your rings? Also, I am using the same lug nuts that were used with the stock 15 inch basketweaves. Could this be a problem?? -Thanks

[liquidtiger720]

You'll be fine with the OEM lug nuts.

My rings were provided by Pete. But my ring diameters are different.

If you call tirerack, they do sell the more common ring used for bmw's the e39 hub size to the rest of bmw line hub size.

[E34 530]

632 regal, can you tell me what centric rings you are running. Do you also have e39 rims on your car? Can you tell me where and how much your rings cost you. -Thanks

[RobPatt]

... think the part # is like t790 or something... and think it's like 72.4 to 74.. but if you tell them it's to put E39 wheels on an E34 they'll be able to figure it out for you.... the metal ones will rest into the wheel, then put the wheel on the hub... if you put the ring on the hub and press it flush, it'll miss the wheel and the hub is deeper than the portion of the wheel that sits on the hub... (thus put the ring onto the wheel, then carefully put the wheel onto the hub... -Rob.

[632 Regal]

ummm....double check the lugs (how much sticks through the back of the wheel) compared to the new ones, too long and they can go too far through and hit stuff...too short and tour wheels can fly off.

You'll be fine with the OEM lug nuts.

My rings were provided by Pete. But my ring diameters are different.

If you call tirerack, they do sell the more common ring used for bmw's the e39 hub size to the rest of bmw line hub size.