Rear brake question

[Russell]

I just installed (about 500 miles ago) new front rotors and Raybestos QS pads. I now notice the rear wheels are dusting up much faster than before the new pads. Everything seems to work well.

Did new front pads cause the rear brakes to work "harder" than before? Do I need to bleed the brakes for some reason? Or am I just trying to find something to worry about?

[Robert K]

If you have the original pads on the back, they dust just like your original fronts did. However, you just put pads that are near dustless on the front (I also have these Raybestos pads all around). So, whereas your fronts are now producing much less dust, your rears are producing the same amount as before. Therefore, it will appear that the rears are working harder, which they are not...they're just producing more dust. If it bothers you, you need to put the Raybestos on the back too.

Grace and peace,

Robert K
1991 535i

[Russell]

I am almost sure there is more dust on the rear wheels than before. Good to know there are rear QS pads. I had heard they were not available.

Thanks

If you have the original pads on the back, they dust just like your original fronts did. However, you just put pads that are near dustless on the front (I also have these Raybestos pads all around). So, whereas your fronts are now producing much less dust, your rears are producing the same amount as before. Therefore, it will appear that the rears are working harder, which they are not...they're just producing more dust. If it bothers you, you need to put the Raybestos on the back too.

Grace and peace,

Robert K
1991 535i

[632 Regal]

the new pads might not bite the same as the old rears, id say replace the rears with matching and then go bed them in.

[Russell]

Plan to order new rear QS pads asap.

[billb]

Do I need to bleed the brakes for some reason?

It's a good habit to get into. It could be that you introduced a little air bubble when you compressed the front calipers to get the new pads on, and you're getting a little bubble compression at the front while the rear is all fluid. Give that a shot before buying anything new. If I'm wrong, heck, you're out a couple ounces of brake fluid.

You are flushing brake fluid annually, right?

[Russell]

well- two years ago...

[Bellicose Right Winger]

Sorry, it's not possible for air to enter the system by pushing the piston back into the caliper during a pad change.

Paul Shovestul

I always bleed when installing new pads... It's a good habit to get into. It could be that you introduced a little air bubble when you compressed the front calipers to get the new pads on, and you're getting a little bubble compression at the front while the rear is all fluid. Give that a shot before buying anything new. If I'm wrong, heck, you're out a couple ounces of brake fluid.

You are flushing brake fluid annually, right?

[billb]

Sorry, it's not possible for air to enter the system by pushing the piston back into the caliper during a pad change.

Paul Shovestul

I never say never when it comes to hydraulics. Perhaps he opened the bleeder screw to compress the piston?

[Russell]

did not open bleeder screw