Finding a short?

[Mr. BILL]

Hey guys,

My son's '84 Mustang has a power drain somewhere and I'm not sure how the proceedure to find it works.

The battery testes OK and it's only 7 months old. Same with the alternator. I disconnected the aftermarket radio thinking that might be the source, but no. Voltage will drop from 12.5 to 11.5 overnite. I know there's a procedure that involves a multimeter in series with the neg battery cable and pulling fuses.

But, when it comes to electrical issues, I'm a real beginner. Could someone walk me through it and please be specific. The only function of a multimeter I'm familiar with is checking voltage, so please specify what I should set it to.

Thanks in advance.

[Javier]

The meter should have an A scale (Ampere) for reading current. Preferably, a High amp one (10A for example). In some of them, this high amp scale requires the red plug of the wire probes to be connected in a different hole. We do not know the magnitude of the current involved, so in order to preserve the meter, it is better to start reading in this high amp scale.

Disconnect the ground (negative) lead to the battery (electronic devices in the car will loose status when battery is unplugged, so you will need radio code for example), connect the positive (Red) meter probe to the negative thick wire disconnected from the battery, and connect the negative (Black) probe of the meter to the negative battery post. Be sure that the probes are inserted in the proper holes in the meter for the readings (Amp) you intend to take.

If you have the leak as you stated before, you should have a significant reading in the meter (more than 50 milli amps, > 0.05 Amp). If the selected scale do not allow you to have a clear reading of the leaking current and you want to change down scales, do so. Remember that some meters require to select a new hole in the meter for the red probe in order to select a lower Amp (Current) scale.

Once your meter is properly set and you have a good steady reading of the leaking current, proceed to remove, one by one, the fuses on the fuse box. Keep an eye to the meter in order to identify which fuse removal is dropping down the current in the meter. The leaky circuit is feed by that fuse.

Investigate what devices are associated to that fuse, plug the fuse back, and start disconnecting all devices one by one until you get again a reading drop. That device would be the culprit.

Javier

[Mr. BILL]

Thanks!

I followed your directions and got a reading of .074-.075 except when I pulled the horn fuse. Then, it would drop to .001. After a few seconds, it would recycle to something like 4.25, then .075, then drop to .001.

I'm going to leave the horn fuse out overnight and see if the voltage drops.

I really appreciate your excellent instructions!

[Javier]

if the current reaches 4 amps AFTER removing horn fuse, something else is causing a big leak.

Also, a leak of 75 mA shouldn't drop 1 volt, overnight, an "in good shape" battery.

Javier

[Gene in NC]

Thanks for the timely posts. This is my project for the day.