EAT chip

[jsvizijr]

I was in the process of installing my EAT in my 1995 525i and found that there are two small torx screws (in addition to 4 #20) holding the DME assembly together.

Any idea what size the small torx screws are?

TIA,
Joe

[MarkD]

I was in the process of installing my EAT in my 1995 525i and found that there are two small torx screws (in addition to 4 #20) holding the DME assembly together.

Any idea what size the small torx screws are?

TIA,
Joe

Hi Joe,

for all DME's you only need to remove the #8 torx screws. If there are any small ones on the bottom of the DZME, you don't need to remove them.

Mark

[jsvizijr]

Hi Joe,

for all DME's you only need to remove the #8 torx screws. If there are any small ones on the bottom of the DZME, you don't need to remove them.

Mark