Printable View
Didn't you say they used the same H1 bulb as the originals? These aren't allowing the bulbs I have from the Originals to seat properly. It looks like I might be able to refit the wire clip with the bulb in place but its obviously not seated in the area manufactured in there . I can't get a reply from the seller either. Maybe H3? I'd hate to have to do this by a process of elimination at like $7.00 a bulb.Quote:
Originally Posted by Blitzkrieg Bob
don't the HKplus hong kong ones use h3?
Quote:
Originally Posted by attack eagle
yup, H3
I see what someone said about their fit being a bit off. They are about 1/8" shy of taking up the whole cutout at least on the left so far...peobably wont be noticeable till you're face is down there but I'll take a pic wqhen they're in hopefully tomorrow.
Do you think it'd be smart to maybe seal around the rubber back cover with some removable gummy gunk or window sealer maybe? hate to have that pop off in a rain storm.
is the concensus then 'Don't buy chinese parts for your BMW'?
Do they look that bad?Quote:
Originally Posted by billy
Quote:
Originally Posted by Jehu
I was refering to the build quality
like i noted before the back cover/cap is rubber with these. The Hellas are hard plastic. If these leak or come off easily that might be an issue. Other than that no other dramaticly cheap aspects which were of any concern to me. I'll say something if I have any problems.Quote:
Originally Posted by billy