Joe Here from Orlando
Since I just changed the water pump I noticed my engine really needs to be steam cleaned good. Any recommendations? Also I need a good wax or waxing compound, because my car have some fading of the paint on top, Any Suggestions would be highly appreciated?
One last thing, do anyone know of a BMW club here in Orlando?
Zaino is a very good wax from what i have heard. You will probably want to clay bar as well. www.detailersclub.com is a very good resource for detailing stuff.
You probably do not want to steam clean your engine, you can mess up the electricals. If you must, cover all electric stuff in plastic and spray a degreaser on your hot engine. Wait a few minutes for it to soak in and then spray it off with a stream of water. Personally, i just use a rag, some simple green, and a lot of time.
I just finished reading an article explaining why you DON'T want to steam clean your engine
http://tridem.han-solo.net/auto/eric...g/cleaning.htm
I cant imagine why it would be reccomended to have the engine as operating temperature. I think it should be cold, you dont want to hit a hot metal with cold water, this can cause cracks, deformation ect. No matter what type of metal. A cold engine with a good degreaser and mild pressure will do the trick.
-Ben
the gunk you want to wash off will be more easily removed when heated up.The metal won't crack from the temeraptures in play, you're not using liquid nitrogen are you?Quote:
Originally Posted by BlueM60
Cracking and warping...is this true? Are you pulling my leg? I sure hope that the engine never gets so hot that it will crack with cold water being thrown on it... What happens if it rains and you drive through a puddle, or even in slushy snow? Since you're constantly cooling it off, that the temperature differential shouldn't cause any cracking or warping issues...I don't think ;) ...at least I hope not.Quote:
Originally Posted by BlueM60
the blocks are aluminum, not iron....
i wouldnt do it with the engine at "normal operating temprature" i would wait until it was warm or hot to the touch.I wouldnt steam clean or use a hih pressure cleaner though...degreaser and lots of elbow grease for me.
.
Do not steam clean! moisture will creep into most electical connections and may damage it. Search the archives for tecniques.
Waxing/sealing the finish is only a portion of detailing. It is done last after you clean, polish and prep the paint. General rule, use the least agressive polishes that do the job. Again search. Also look at Roadfly's detailing forum, Autopia or similar forums for more than you want to know about the world of detailing.
Try Duragloss 105 sealant. Low cost OTC at Napa or Carquest. Seems to work very well with high gloss and reflectivity. Seems durable. Beads water even covered in dirt. As usual, will need to prep paint before application.