Inspection light

[kentish]

Hi to everyone

the inspection light (the one with the small clock comes on with the oil inspection lights when the key is set to 'on' and once the engine is running, everything goes away after a few seconds

Is it normal? I did not notice that, its just today that came across that.


Kentish
540ia 1994

[staffbull]

according to uk spec manual it means you need to change your brake fluid at next sevice

[632 Regal]

is supposed to happen at this time.

There is inspection 1 and inspection 2 where different things are inspected and replaced each service period.

If you dont have good maintenence records the whole inspection should be performed and periodic replacement items replaced and or serviced such as brake fluid, antifreeze, power steering fluid, oil, trans fluid, rear end fluid water pump, thermostat, hoses etc etc.

Or you could just reset the lights and forget all about it.

;)

[kentish]

thanks for replies. I will just need to reset it as all the mainteance of the above items have been done recently.

[jsvizijr]

Without a reset tool, how do you reset the light? I have a 95 525i

[632 Regal]

Without a reset tool, how do you reset the light? I have a 95 525i