valve adjustment tool?

[panzershreck]

is there anything i can use to substitute buying the tool with? nobody in my area has one

[gale]

Anything with a 3mm (0.120") diameter should work, i.e. a nail with the tip filed blunt, end of a drill bit, etc. I happened to have some wire laying around the exact diameter so made a set with different bends in them:

http://www.nmia.com/~dgnrg/valves2.jpg



http://www.nmia.com/~dgnrg/page_5.htm

[winfred]

i use a allen wrench, i can't remember the size at the moment

[panzershreck]

easy enough, just bent some 3mm nails