1990 525 touring hazard and directionals stopped working

[Jachenbach]

Good Morning from San Diego,

i have a 1990 525 wagon with 186,000 miles. I replaced the interior with a set from a 1995 in great shape. I also fixed the cables on the lift gate that rubbed to bare wire which repaired the rear taillight from staying on. I also replaced the brake light switch which cleared the brake light code on console.
Yesterday, my directionals stopped working, I tried the hazards and they also do not work. I replaced both hazard flasher relay and the crash control unit. Bulbs, LCM and check control module all ok. Fuse 2,3,6,13 and 14 ok as well. Any suggestions.

[Jachenbach]

After attempting to read electrical diagrams in the Bentley manual I am unclear if the general relay (under the back seat) could be a source of the problem. Has anyone replaced this and why?

thanks, jim

[Jachenbach]

Replaced relay module and general module with no change

[Jachenbach]

FIXED! Should have checked the flasher switch must have damaged it when I swapped the interior. Problem was the flasher switch

[shogun]

You can open and clean/repair it. All kinds of switches opened which shows how to replace the bulbs
BMW ƒ�ƒ“ƒeƒiƒ“ƒX‹L˜^ (http://dd.jpn.org/BMW_HP/20080610/index.shtml)

[Jachenbach]

Thanks