PDA

View Full Version : oil pump



allerston
10-28-2009, 02:56 AM
what are the signs should i look for if the oil pump is going bad .
can the oil pump be replaced by opening the oil pan from under the car or do i have to take the engine out.

h2oyo
10-28-2009, 12:06 PM
what are the signs should i look for if the oil pump is going bad .
can the oil pump be replaced by opening the oil pan from under the car or do i have to take the engine out.

I know you can change the oil pump from under the car on a 540 and I would think it would be the same for you. As for signs of a bad oil pump I would drain the oil and open it up and have a physical look at everything. I would think the next thing would be to check oil pressure. I'm not all to sure how to go about that but i'm pretty sure somebody here can tell us how its done. I dont know if I thought there was an issue with my oil pump I think I would change it out, has to be much cheaper than an engine rebuild.
Johan

Scott C
10-28-2009, 04:37 PM
I did a 95 525 without pulling engine.... I had a valve tappet noise issue at idle. First thing I did was remove the low pressure warning sensor and put in a gauge....

See below link
http://www.bimmernut.com/forum/showthread.php?t=41802&highlight=Scott

There are a million friggen bolts - take your time, look at REALOEM to see them...