MAF Wiring/Numbering

[Luftpost]

Searched, but could not find....

My MAF appears to be inop (visual burn off test failed), so I need to check the voltage. I have a 4 pin connector. The wires are colored:

Brown with Orange stripe
Grey w/ Yellow Stripe
Red w/ White Stripe
Black

Does anyone know which wire is associated with pin number as referenced in the Bentley manual.

I need to test Pins 1 and 4 for burn-off voltage, and then pins 2 and 4 for voltage test.

Thanks!

L.

[Ross]

You have them listed in numerical order, bn/oe is #1 etc. Pretty sure the connector is maked too.

[Luftpost]

You have them listed in numerical order, bn/oe is #1 etc. Pretty sure the connector is maked too.

Thanks for the quick response!!

I looked more carefully at the connector, and you are correct! There are some very small numbers there to id the wires.

I see in the Bentley manual that there are 6 wires on their connector. I have four. Do I still test wires 1 and 4?

I am not getting any burn off voltage across 1 and 4 at his time.

L.

[Luftpost]

I see in the Bentley manual that there are 6 wires on their connector. I have four. Do I still test wires 1 and 4?

I am not getting any burn off voltage across 1 and 4 at his time.

L.

Anybody with any advice on how to test the four pin connector?? Anybody....?