PDA

View Full Version : Replace Centre Bearing Assembly


GJPinAU
04-30-2009, 02:30 AM
on driveshaft.

DIY or DYI?
shogun
04-30-2009, 02:32 AM
of course DIY. No problem to do. Bruno has it on his site, or also on my site under lots of DIY links>Johan & Sean
632 Regal
04-30-2009, 06:03 PM
about the worst part is the exhaust and accompanying nuts/bolts.
Jeff in MN
04-30-2009, 06:17 PM
about the worst part is the exhaust and accompanying nuts/bolts.

studs that attaches the exhaust to the exhaust manifold. When removing these nuts, first drive them clockwise a quarter turn to bust them loose, then back them out with impact wrench if possible. A lot depends on the RUST level.
Good luck.
GJPinAU
05-07-2009, 06:43 PM
OK, you've convinced me.

As soon as the part arrives its off to the Indy!
GJPinAU
05-22-2009, 12:32 AM
Indy replaced the bearing but now has a driveline vibration at about 45kph under load (accelerating) but not cruising speed.
He has checked all he can think of (pre load, donut etc)

Any thoughts?
632 Regal
05-22-2009, 05:25 PM
he might have assembled the 2 halves out of sync? I dont know if you have the 2 piece shaft or not.