Oh no! Timing trouble

[infurno]

I think I made a huge mistake. I'm installing the new cylinder head and changing the timing belt.

I aligned the engine to TDC and as I was loosening bolts to remove the vibration damper the marks became unaligned. On the last bolt I accidentally hit the vibration damper with the wrench and the thing slid off. I put it back on immediately but its possible it shifted.

This may be a disaster. Is there any other trick to double check?

[infurno]

Looking at the Bentley manual I see a section about another notch on the crankshaft hub to align with the front engine cover. I think thats all I have to do, then just install the vibration damper onto TDC and it should be fine.

If I'm wrong please let me know.

[infurno]

Never mind.. That was silly.. turns out that you can't install the vibration damper incorrectly even if you tried.

Everything is ok :)

Please feel free to delete this thread.