PDA

View Full Version : still can't get turn signals to work.



jjdickm
12-15-2007, 05:02 PM
I have tested the fuse and it checked out. The signals will not turn on even with the emergency flasher button on. I don't know if there is a relay i need to check or what. any ideas?

icesoft
12-15-2007, 06:06 PM
I have tested the fuse and it checked out. The signals will not turn on even with the emergency flasher button on. I don't know if there is a relay i need to check or what. any ideas?

Hazard Flasher Relay (K16) in the front PDB, lower left corner next to the check control module, it is what controls the power to the lights. Otherwise, recheck fuses 3 and 6 in the front PDB. Check to make sure that the signal is getting to the relay from the stalk, pins 2 and 7 on the relay are the left turn and right turn inputs, pin 9 is the hazard input.

Pin 4 is the left turn signal output, Pin 5 is the right turn signal output. Also check continuity to ground on pin 8.

shogun
12-16-2007, 12:12 AM
There is a relay, check here the location based on production year
http://shark.armchair.mb.ca/~dave/BMW/e34/