PDA

View Full Version : Oelstand motor warning!!!



colamangr
06-30-2006, 02:45 PM
Hello!

The Check Control today gave me Oelstand motor. What is this???????:(

colamangr
06-30-2006, 03:30 PM
Oh i forgot! The car is a M5 with a S38b38.

Ross
06-30-2006, 03:43 PM
The German speaker in my home is out of town but I believe it to mean oil level.

Blitzkrieg Bob
06-30-2006, 03:48 PM
It's your Oil level...Das ist low

check the dip stick and look for the cap that says 710

Espen
06-30-2006, 04:03 PM
You can change your checkcontrol language by holding down the checkcontrol button for 10 seconds while key is in pos 1(maybe it was pos 2) and engine off.
For the next language, do the procedure again.

colamangr
06-30-2006, 04:10 PM
I checked the dip stik and it was between the two lines not very low... It's time for inspection so maybe the oil is old!

colamangr
06-30-2006, 04:13 PM
You can change your checkcontrol language by holding down the checkcontrol button for 10 seconds while key is in pos 1(maybe it was pos 2) and engine off.
For the next language, do the procedure again.
I tried that and only the obc language changed. Also when i did this, the Uk, Us or other languages were displayed in the obc and not in the cluster!

Blitzkrieg Bob
06-30-2006, 04:16 PM
Old oil dosen't throw a level warning. sometimes hard driving can trip the sensor, parked on a hill....things that would change the level in the pan.

The plug for the sensor is low on the engine, and some times gets dirty and sends false warnings.

Mine did that for a few months, then I had to get onder the car and fix it.

Be careful the plastic on the plugs are very brittle.

colamangr
06-30-2006, 04:31 PM
I droved it hard this morning and now i get this. It is parked at a road with a little leverage... Is it because of that? Is that sensor expensive?

Blitzkrieg Bob
06-30-2006, 04:49 PM
did you restart the car after?

It may just go away.....after all has settled down.

If it persists, then check the sensor wiring and plug before looking to replace the whole thing.

colamangr
06-30-2006, 05:02 PM
did you restart the car after?

It may just go away.....after all has settled down.

If it persists, then check the sensor wiring and plug before looking to replace the whole thing.
Thank you very much! The inspection light came up so they will check it up!

Paul in NZ
06-30-2006, 05:03 PM
The oil level warning comes on in my car when the oil level is about halfway between the marks.Add 1/2 litre or so and see if that fixes the warning

colamangr
06-30-2006, 05:18 PM
The oil level warning comes on in my car when the oil level is about halfway between the marks.Add 1/2 litre or so and see if that fixes the warning
The level of the oil is exactly there, halfway between the marks! I will try that tomorrow and i will inform you!

632 Regal
06-30-2006, 08:22 PM
yep same as Pauls, right about the middle of the grooves I get the oil message.

BillionPa
06-30-2006, 10:39 PM
when i removed my sensor, it was pretty gummy.

after spraying it out with brake cleaner (half a can, for about half an hour), it was much much cleaner and you could hear the little thing inside that moves again!

if you do that, make sure you get a new o-ring