So I FINALLY get around to working on the new CD43.

Many thanks to Denny for sending me a stock amp.

I was able to connect all 24 some-odd wires at the amp end, splicing them one at a time. I hooked up the new CD43 up at the dash, so far so good.

Turn on the car, and no power to the amp, no power to the memory line on the CD43. Ignition line is fine (i.e., switched 12V works fine) but the constant 12v line is dead.

Anyone know where the fuse for this red/white for the stereo is? Also - how about the +12V to the amp?

I looked in Bentley, which directed me to the underneath of the rear seat, but all I see is a well-tied rat's nest of wires and a half dozen UN-NUMBERED fuses...

SO - any ideas on how to check why the 12V constant to the amp and to the radio are zero? Many Thanks!!!!!!!!!!