Winfred included and install them on a wide variety of cars..
In my experience the raybestos qs series have been the best pads I've put on any cars. I get no complaints whatsoever about noise or dusting from customers with them. I have installed virtually every pad out there in the past and these are the best I have found for overall street use. The only ones i haven't installed on a customers car that was mentioned is the EBC's that Phil uses... other than that I've installed every make you have listed and still have the best results with the raybestos QS, If you decide to get raybestos make sure its the QS and not one of the other series such as raymold or pg plus... You can get them from any checker store, pepboys or partsamerica.com online. IF you call around in your city I'm sure you 'll find a number of stores that carry them. As far as the rotors go I have had good results with both the ate powerdiscs and balo conventional rotors. Both are reasonably priced and work well.









Quote Originally Posted by nuwde
hey guys, i'm checking out bma for new front and rear pads and rotors. there are a lot of brands. what do you guys suggest for a 92 525i? ATE, Friction Tech, Jurid, LPR, Mintex, PBR, Pagid, Textar (there are a bunch). Will I need to buy the sensors? I'm open to any suggestions you guys have.

Also, are rotors called brake discs? Do i need to go for cross-drilled? Got any suggestions there? Thanks for all the help guys!

Edwin