Hi, I plan on doing a 5 spd swap into my 1995 525ia. I was wondering if the 528i tranny is the one I need to get.Originally Posted by penguin
Can anyone give me a hint as to which driveshaft will fit with this swap ? I have a 528i transmission to swap in and my current drive shaft flex disk off the 525i is a tad too small in diameter for the holes to lineup... On the same note will the shift linkage swap over from the 525i tranny to to the 528i tranny ?
Hi, I plan on doing a 5 spd swap into my 1995 525ia. I was wondering if the 528i tranny is the one I need to get.Originally Posted by penguin
95 BMW 525i black/black
-E.A.T. chip
-Blacked out grill and window trim
-17in AC replicas
-Blistein shocks & H&R springs
-Cadmium plated Brembo rotors
-Raybestos QS break pads
you could use that one...i think that is the getray tranny though (correct me if i'm wrong)Originally Posted by kngpen
i used the ZF M3 tranny from the E36 though...just as another option. it's a tad more expensive, but it's stronger.
penguin,
was your old engine an M50tu? have any more extensive info if it is?
may be interested
Originally Posted by Pinoy2145
My 1994 525i 5 speed does use the M50TU engine with the getrag transmission . I want to put in the e36 transmission but the flex disks aren't the same. What kind of info about it are you looking for? It's still in the car and I use it daily yet, until I get all the parts for the swap... after that both the engine and transmission will be up for sale.
My real last hangup is this driveshaft problem... and which driveshaft I use (say does the rear of the 528i driveshaft mount up with my current differential), or can I use my old driveshaft by removing the flange off the old transmission and putting the flange on the new ZF transmission ?
Thanks for any help someone could provide...
.