GO FISHING, use SLABSAUCE Fishing Attractant
Results 1 to 3 of 3

Thread: How to pull out rear diff output flange?

  1. #1

    Default How to pull out rear diff output flange?

    Hi,
    I manage to get rear diff with ratio 3.64 with the right bolt mount point.

    But seems i need to swap the output flange from my original 4.45 rear diff into this diff. How to pull this out?

    Appreciate for any hints.

    thanks,
    rahman
    Rahman in Kuala Lumpur,
    1988 520i M20B20
    1988 730i M30B30
    1982 323/6 M20B23
    1980 316
    1984 GPZ550

  2. #2
    Join Date
    Dec 2003
    Location
    baton rouge, loserana
    Posts
    6,922

    Default

    block of wood and a hammer if you can't get it out by hand
    all america wants is cold beer warm cat and a place to take a poop with a door on it

  3. #3

    Default

    Got it!!! I used wrench extension to pry it out. I used hammer. The one from the car was popped out just by hand, interesting, too easy...

    Thanks.
    Last edited by nsbone_1988_520i; 12-15-2004 at 10:11 AM.
    Rahman in Kuala Lumpur,
    1988 520i M20B20
    1988 730i M30B30
    1982 323/6 M20B23
    1980 316
    1984 GPZ550

Similar Threads

  1. 5/16'' gap between flex joint and trans. output flange?
    By ryan roopnarine in forum 5 Series BMW
    Replies: 19
    Last Post: 03-31-2009, 10:08 AM
  2. Transmission Output Flange Seal Replacement
    By Rus in forum 5 Series BMW
    Replies: 5
    Last Post: 08-11-2006, 07:18 AM
  3. Play in the transmission output flange...
    By baileydog in forum 5 Series BMW
    Replies: 1
    Last Post: 04-23-2005, 10:18 PM
  4. Success! Finally got the tranny output flange off . . .
    By gale in forum Stuff over a year old
    Replies: 3
    Last Post: 02-10-2004, 01:18 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •