GO FISHING, use SLABSAUCE Fishing Attractant
Results 1 to 7 of 7

Thread: Help can't get into boot

  1. #1
    Join Date
    Oct 2004
    Posts
    2

    Default Help can't get into boot

    HI All
    I am unable to open my boot on my e34 525i 1990 the button goes in ok I can use the key to lock and unlock the rest of the car but the darn boot fails to open.

    ANy Ideas how to gain access?

    Cheers

    G

  2. #2
    Join Date
    Dec 2003
    Posts
    835

    Default

    This is gonna be no fun at all.
    I'm guessing the linkage from the lock to the release popped out? You'd go into the trunk from the rear armrest area. I'd loan you my 7 year old first born, legitimate son, but he may be too big to get in there. The trunk liner would need to be pulled away once in there. The latch to be levered, is at the center of the trunk.
    erased due to slander

  3. #3
    Join Date
    Oct 2004
    Location
    Bay Area, CA
    Posts
    261

    Default

    Quote Originally Posted by mrbig_g
    HI All
    I am unable to open my boot on my e34 525i 1990 the button goes in ok I can use the key to lock and unlock the rest of the car but the darn boot fails to open.

    ANy Ideas how to gain access?

    Cheers

    G
    If this is the latch problem, It has happened to me before. That hole in the armrest area is SOOO small, What I had to do was get creative and grabe a broom stick, make a hook on the end and pull the trunk lining away (I did have to tear it around two clips, but hardly noticeable) Once I did that, I looked for the latch and used my homemade hook to pull it. Took about 3 hours. Hope this helps some.

  4. #4
    Join Date
    Dec 2003
    Location
    Austin, TX
    Posts
    1,181

    Default

    try pushing the button while locking and unlocking it. Also might try some lithium grease in the keyhole.
    1995 540iA M-Sport - 76k miles. 1 of 1 auto AW3 cars.
    1995 540i/6 - Misc Parts donor for above.

  5. #5
    Join Date
    Dec 2003
    Location
    Eastern Tennessee USi
    Posts
    14,839

    Default

    plastic explosive? I do like the broomstick hook idea prior to the plastiques.
    95 E34 530I V2.37
    ===========
    Those who make peaceful revolution impossible will make violent revolution inevitable.

    John F. Kennedy

  6. #6
    Join Date
    Jan 2004
    Location
    Albuquerque, NM
    Posts
    953

    Default Trunk lock . . .

    Make sure the battery charge is full up. Cycle the solenoid with the key dozens of times or more if that's what it takes, might get lucky. Here's some more detail how to fix it once you get it open:

    http://www.nmia.com/~dgnrg/page_38.htm

    Good luck!
    gale
    92 735i 5-spd, turbo project finally underway!


  7. #7
    Join Date
    Oct 2004
    Posts
    2

    Default Solution to access the boot/Trunk be warned it is brutal

    Nope plastic was not required one hole drilled ( told you it was brutal) 10 inches to the left of the button enabled me to activate the latch manually. Then reconnet the rods that had come off put some paint round the hole seal with a grommet and cover with the number plate job done.

    Thanks for all the suggestions

Similar Threads

  1. Anyone have an intake boot
    By 632 Regal in forum 5 Series BMW
    Replies: 19
    Last Post: 12-22-2008, 12:07 PM
  2. OT PC won't boot
    By BobHarris in forum 5 Series BMW
    Replies: 10
    Last Post: 05-13-2007, 04:42 PM
  3. CV Boot Part #?
    By m0bius in forum 5 Series BMW
    Replies: 1
    Last Post: 06-23-2004, 07:05 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •