GO FISHING, use SLABSAUCE Fishing Attractant
Page 1 of 3 123 LastLast
Results 1 to 10 of 25

Thread: 95 525i shutters and loses power at 2500 rpms to 3000 rpms

  1. #1
    Join Date
    Oct 2005
    Location
    KY
    Posts
    48

    Default 95 525i shutters and loses power at 2500 rpms to 3000 rpms

    Hey Pros,
    Done a lot of research on your site trying to find the answer. We had multiplee issuess idle problems and such and check engine light. We have lamda code and o2 sensor code.

    The car was having an idle problem for awhile and starving for fuel.
    Finally one day when accellerating it would shutter starting at 2500 /2800 rpms up to 3000 rpms.

    We also had oil in the plugs and a blown gasket.

    We replaced the gasket, several coil boots, plugs.

    Also new MAF, New fuel pump, new O2 sensor, new fuel filter and I think some other stuff as well.

    Got rid of the idle issue and can tell has more power however it still shutters on accelleration once you reach 2500/2800 rpms to 3000 rpm.

    It some times acts like it clears out but when you continue to accelerate it goes back into the shuttle.

    Often cannot go 65 and if you can get it to clear out it breaks down agan at 75.

    Any idea what next? New coils? Could it be the injectors?

    Also we clean out the cats too, not more cats.

    Let us know.

    Thanks,
    Denise and Al
    Ride safe and ride long!

  2. #2
    Join Date
    Oct 2005
    Location
    KY
    Posts
    48

    Default RE: Still need help here guys today we replaced coils,boots,plugs,gaskets/seals again

    No one has anything for us on this issue???
    **************************************
    Quote Originally Posted by caqueenslace View Post
    Hey Pros,
    Done a lot of research on your site trying to find the answer. We had multiplee issuess idle problems and such and check engine light. We have lamda code and o2 sensor code.

    The car was having an idle problem for awhile and starving for fuel.
    Finally one day when accellerating it would shutter starting at 2500 /2800 rpms up to 3000 rpms.

    We also had oil in the plugs and a blown gasket.

    We replaced the gasket, several coil boots, plugs.

    Also new MAF, New fuel pump, new O2 sensor, new fuel filter and I think some other stuff as well.

    Got rid of the idle issue and can tell has more power however it still shutters on accelleration once you reach 2500/2800 rpms to 3000 rpm.

    It some times acts like it clears out but when you continue to accelerate it goes back into the shuttle.

    Often cannot go 65 and if you can get it to clear out it breaks down agan at 75.

    Any idea what next? New coils? Could it be the injectors?

    Also we clean out the cats too, not more cats.

    Let us know.

    Thanks,
    Denise and Al
    Ride safe and ride long!

  3. #3
    Join Date
    Oct 2005
    Location
    KY
    Posts
    48

    Default

    We replaced the complete coils, boots, spark plugs/seals, and the value gasket again.
    Reset the computer still missing when it accelerates.

    It idles beautiful so it doesn't appear to be an injector issue.
    Ride safe and ride long!

  4. #4
    Join Date
    Oct 2005
    Location
    KY
    Posts
    48

    Default

    Just pulled the muffler, still doing it. Do we need to unhook the battery to reset the computer after we took this muffler off. After we replaced the coils, we rest battery and drove it. Will the computer still recognize the fix if it is the muffler?

    Anybody out there?

    I'm miss my car
    Ride safe and ride long!

  5. #5
    Join Date
    Feb 2006
    Location
    Oldham, England
    Posts
    3,078

    Default

    Thought I replied to this so if this is a duplicate my apologies. You will know that oil on plugs means worn valve guides or rings/bores. Any blue smoke? Lambda and O2 sensor are the same depending on which side of the Atlantic you live arent they? What fuel pressure have you got when engine off/running? What inlet vacuum have you got? Have you got any codes now?Is your throttle cable adjusted? - even with all the above you should still be able to get more than 75 mph. Are your brakes running hot?

  6. #6
    Join Date
    Oct 2005
    Location
    KY
    Posts
    48

    Default

    Thanks for responding!! Appreciate it.

    I might have phrased that wrong, no oil on plugs!! had oil in plug holes from gasket blown. Fixed that.

    No blue smoke. No check engine light so we should should not have codes. We cleared up the Lamda and o2 sensor codes.

    This is what we replaced with brand new parts.

    Fuel pump
    Fuel filter
    O2 sensor
    Mass Air Flow
    6 coils w/ boots
    cats
    bosch plugs w/seals
    valve gasket
    pulled muffler off didn't work

    Have fuel pressure but we have not tested it with the car off. should we with the new fuel pump installed?

    Have not tested the inlet vacum, will do this.
    No codes unless one may show without a check engine light on?
    Have not checked the throttle cable adjustment. Was perfect but will check that too.

    The car runs perfect at idle and light tippin but hard acceration acts like the timing is off.
    How do you check the timing on this car? What advances the timing do you know??

    Its got brand new brakes and rotors and they are not running hot.

    This is intermitent too. You can get it to 75, 80 but goes through the shutter, sometimes clears out sometimes does not. Runs awesome when clears out. But can't get it past 80 shutters evertime at 79.

    Still thinking worn value guides or rings and bores?
    With the valve cover off, top part of the engine looks awesome.

    Thank you for responding anything else you can offer would be great. We'll get those tests done and report back by tomorrow. Please check back for us.

    THANK YOU!!!
    Ride safe and ride long!

  7. #7
    Join Date
    Dec 2003
    Location
    PA
    Posts
    5,403

    Default

    Have you tried the crank position sensor?

  8. #8
    Join Date
    Oct 2005
    Location
    KY
    Posts
    48

    Default

    No, not yet, should we?
    Ride safe and ride long!

  9. #9
    Join Date
    Dec 2003
    Location
    Eastern Tennessee USi
    Posts
    14,839

    Default

    cheap part, make sure the gap is correct to the tight side.
    Quote Originally Posted by caqueenslace View Post
    No, not yet, should we?
    95 E34 530I V2.37
    ===========
    Those who make peaceful revolution impossible will make violent revolution inevitable.

    John F. Kennedy

  10. #10
    Join Date
    Oct 2005
    Location
    KY
    Posts
    48

    Default

    Got one on the way $47 US. Should have it by Tuesday.

    We appreciate all your help guys. It can be so frustrating coming this far with all
    we have replacement without it fixing it 100%.

    We fixed check engine light. New fuel pump did that after we replaced the MAF and O2 sensor.

    Car had a few things going on at onces.

    Should drive like a dream again once we fix this shutter.

    What is that big pipe or should say bomb that goes before the muffler? We couldn't put that back on yesterday when we pulled the muffler. Some pieces are broken on it.

    We will right back with results!

    THANKS!!
    Ride safe and ride long!

Page 1 of 3 123 LastLast

Similar Threads

  1. complete loss of power at high rpms
    By jofusfarr in forum 5 Series BMW
    Replies: 22
    Last Post: 01-08-2010, 09:11 AM
  2. ABS kicks on at low RPMS
    By misfortune in forum 5 Series BMW
    Replies: 7
    Last Post: 06-28-2008, 09:13 PM
  3. Replies: 23
    Last Post: 04-18-2006, 12:35 AM
  4. RPMs in 5th gear?
    By miliue in forum 5 Series BMW
    Replies: 4
    Last Post: 11-16-2005, 05:32 PM
  5. Idle RPMs and Carfax
    By Matias in forum 5 Series BMW
    Replies: 1
    Last Post: 10-21-2005, 10:30 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •