GO FISHING, use SLABSAUCE Fishing Attractant
Results 1 to 3 of 3

Thread: Check your Oil Pressure Sender?

  1. #1
    Join Date
    Dec 2003
    Location
    Central NJ - USA
    Posts
    1,540

    Default Check your Oil Pressure Sender?

    i got an error message from the dash so i ordered an oil pressure sender
    from bma. took it to the mech and he replaced it. still got the error.
    told him to fix it...the wire coming from the car has 2 pins the sender
    bma sent me has 1 pin. the alldata tech sheet for a 91 535i shows a
    1 pin OilPSender. what do u guys have? we tried connecting the two
    and grounding each one but still the compy throw the dash error. only when
    u turn the car off though =[

  2. #2

    Default

    The sender only needs one connection to the car's loom. The goes low (to ground) when the pressure is low so the other pin is not needed unless the sensor features another connection either a dummy or not used on your car. The last M30 sensor I swapped from a non OEM source had one pin, looking at it from the front with the notch upwards the pin too the right is the car's loom pin.

    With the ignition off ground the wire from the loom to the block (you wont breeak anything) then the light should stay on. Turn on and off the ign, you should not get any gong's. If that works then remove the wire from the block and then try the same test the light should stay off. If so then the wiring etc is ok. Next step check out the sensor it might be the wrong one. It is a simple power->bulb->switch->ground setup you should not need anything else.

    The wiring is brown/green for the sender. Anywhere under .5 BAR should bring the light on FYI.

    HTH

    Steve

  3. #3
    Join Date
    Dec 2003
    Location
    Central NJ - USA
    Posts
    1,540

    Default

    thank you very much! i will try this out asap

Similar Threads

  1. installing oil pressure gauge and sender
    By rob101 in forum 5 Series BMW
    Replies: 6
    Last Post: 04-23-2006, 06:04 PM
  2. Check the pressure in your spare!
    By Dan in NZ in forum 5 Series BMW
    Replies: 10
    Last Post: 08-29-2005, 05:54 AM
  3. oil pressure guage sender unit??
    By ukm5 in forum 5 Series BMW
    Replies: 2
    Last Post: 05-09-2005, 06:42 PM
  4. Oil pressure sender?
    By kiNGMak in forum 5 Series BMW
    Replies: 1
    Last Post: 10-28-2004, 06:16 PM
  5. E39 fuel sender
    By dowzer in forum 5 Series BMW
    Replies: 0
    Last Post: 10-11-2004, 10:02 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •