GO FISHING, use SLABSAUCE Fishing Attractant
Results 1 to 3 of 3

Thread: 4hp22 A-clutch pack R&R follow-up . . .

  1. #1
    Join Date
    Jan 2004
    Location
    Albuquerque, NM
    Posts
    953

    Default 4hp22 A-clutch pack R&R follow-up . . .

    The job went quickly, took only about 45 minutes to do the clutches & put the bell housing back on after finishing the oil pump seal & bushing. Then I burned another couple hours dealing with a broken vent dammit at the rear of the trans. Here's a few pic's:

    http://www.nmia.com/~dgnrg/page_43.htm

    Might get around to putting the trans in the car today ... might not.
    gale
    92 735i 5-spd, turbo project finally underway!


  2. #2
    Join Date
    Dec 2003
    Location
    baton rouge, loserana
    Posts
    6,922

    Default

    i hardly ever bother with the broken vents i encounter, it's so far up in the tunnel and fairly well protected on all sides i doubt anything could reach it short of desert racing conditions
    all america wants is cold beer warm cat and a place to take a poop with a door on it

  3. #3
    Join Date
    Jan 2004
    Posts
    4,150

    Default Thanks for the Info Don.

    Between you and Winfred and the Transtec info it pretty much covers it with plenty of pictures.


Similar Threads

  1. Fs S5d 250g Dualmass Flywheel And Clutch Pack
    By Herb in forum 5 Series BMW
    Replies: 0
    Last Post: 11-03-2007, 05:24 PM
  2. Replies: 1
    Last Post: 08-19-2007, 04:03 AM
  3. a clutch pack
    By clarkstreet in forum 5 Series BMW
    Replies: 1
    Last Post: 12-26-2006, 10:33 AM
  4. Which E34?: Follow-up
    By kramsivad in forum 5 Series BMW
    Replies: 4
    Last Post: 08-06-2004, 02:24 PM
  5. i did a 4HP22 today, clutch pics
    By winfred in forum 5 Series BMW
    Replies: 8
    Last Post: 03-17-2004, 09:06 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •