What I'm trying to find out, is if you had to pass power to the sensor to test for a pulse. I assumed power was routed to the sensor from the DME (because the diagram only shows two wires). I'm thinking, how can it pulse if I am just testing for resistance? At that point I'm only sending like a milli-milli-amp right? Is that all the power the computer sends through the sensor?
Lowell, I did *not* have any spark when I tested correctly last night.
I have a volt-ohm meter on my Christmas list.
Also, my wife called today to tell me that my computer disks are in. TIS, finally.
Job 14:1 Man born of woman is of few days and full of trouble.
az