Cam Position and Valve Adjustment

[JMI]

Please settle a disagreement -

It is not truely required for the piston to be TDC when adjusting valves, just that the rocker arm cam followers are completely off of the cam profile, correct?

Thanks

[JMI]

Anybody?

[Alexlind123]

As far as i know, if the eccentrics are off of the cam profile, the valve can be adjusted. Just think about it.

[nizmainiac]

that is correct

[Robke]

that's correct, as soon as the valves are free you can adjust them and you also can adjust them on several cilinders in one time

[JMI]

Thanks all. That is what I thought.

[Alexlind123]

I just used a black marker to mark the rocker arms which had been adjusted.

[zygoteer]

Please settle a disagreement -

It is not truely required for the piston to be TDC when adjusting valves, just that the rocker arm cam followers are completely off of the cam profile, correct?

Thanks

of course !

[Blitzkrieg Bob]

being in the right position 180 from the rocker, because the motor sit at a slant it can lead to mis adjustment.