Results 1 to 4 of 4

Thread: blower resistor replacement ...

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Join Date
    Dec 2005
    Location
    VT
    Posts
    73

    Default blower resistor replacement ...

    OK ... so I have a replacement and located the resistor to the left of the center console. But how in hell do I get the original one out??????? Where it is you need certainly less than my 6'-2 frame to get to it. Then it's held in place by typical BMW plastic restrainers. To top it off the black under dash cover has some kind of shield in front of the resistor.

    Is is
    a) just a real pain,
    b) am I an idiot or
    c) is there a special removal tool.

    ANY answer and help on how to remove it will be greatly appreciated.
    Thanks ....

  2. #2
    Join Date
    Sep 2004
    Location
    Comox Valley, Vancouver Island, British Columbia
    Posts
    39

    Default

    go to http://www.bmwe34.net/e34main/mainte...ical/sword.htm

    Look in the middle of the page, I am six foot two and I was able to do this with a Phillips screwdriver and a bit of contortionism. The resistor is not always easy to pull out, you have to squeeze the clips on the sides and pull out, then plug the new resister into the harness and replace in the opening.

    Cheers,

  3. #3
    Join Date
    Oct 2004
    Posts
    3,395

    Default

    The sword and its replacement is completely different than the later resistor pack.

    If my memory serves, you need a stubby screwdriver. 3x standard phillips hold it in. They may be different fasteners/I've done a lot more e36 resistor packs, which had/have a 100% failure rate from the factory, than I have e34.

    It takes a bit of contortion to get it out; still easier than some things. You may want to remove the knee bolster (find Bill R's dash cluster removal procedure) to get better access to remove the lower vent duct.

    best, whit

  4. #4
    Join Date
    Dec 2005
    Location
    VT
    Posts
    73

    Default

    Thanks guys ... I got it out. Biggest problem was that the under dash cover has this little plastic shield right in front of the resistor. I think It's meant to give the carpeted side cover support. I finally just broke it off since I didn't want to get into the deal of removing the under dash cover which has a lot of vents and opening going through it.

    Once I broke the offending piece off it was fairly easy. Most of all, my blower works again in all positions.

    Thanks again ...
    Last edited by fsteyer; 02-22-2006 at 05:22 AM.

Similar Threads

  1. blower fan problem-not the resistor, solved
    By shogun in forum 5 Series BMW
    Replies: 0
    Last Post: 01-14-2010, 05:44 PM
  2. Valeo Blower Resistor
    By brianwolf3 in forum 5 Series BMW
    Replies: 9
    Last Post: 01-07-2008, 02:24 PM
  3. Blower Resistor Replacement
    By Shankster in forum 5 Series BMW
    Replies: 1
    Last Post: 06-11-2007, 06:49 PM
  4. Where's the Blower Resistor in the 540?
    By Jehu in forum 5 Series BMW
    Replies: 2
    Last Post: 04-29-2007, 09:57 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •