fresh meat for the killing

[winfred]

you think the frame is dammaged!

[Unregistered]

..some of the stuff I saw in an informercial could take that out in no time. It would also restore your health and make chicks dig you.

[632 Regal]

Yes exactly, it's called Pops A Dent and its available at most reputible body shops.

[Chris M]

I wouldn't touch that one with YOUR 10 ft. pole. YIKES !!

[Brian C.]

Looks like a lot of orphans lookin' for homes. What's the engine in that coupe?

Brian C.

[winfred]

s52 3.2 m motor

[Brian C.]

s52 3.2 m motor

[winfred]

actiually i am in the process of building a m20 that will be close to the same power as a s52, ill be a little down on power by time the smoke has cleared ill be around 220, s52 is 240. i think the e30 is lighter but the more modern car has a close ratio tranny

[Brian C.]

.....to be able to have the time, place, access to "projects", and the knowledge to play with things like that. My '95 525ia has the M50tu. When was the last year that BMW used that engine....or is it still used in new 525's?

Brian C.

[winfred]

this is us cars in general too many euro versions to go through

91 was the 1st year of the m50, non vanos, big lumpy cams, no knock sensors, double valve springs, a fun motor nice power surge when on the cam

93 was the technical upgrade "tu" m50, single stage intake cam timing advance, smaller cams, less compression, knock sensors, air mass sensor

96 m52 (328/528) same motor from the outside but with a 1/2" longer stroke same bore, not sure about the specs on the cams but the heads the same

i don't know much about the m54 besides double vanos and aluiminum block