I had a tool built for me to remove the subframe mounts. Pulled the mount on the drivers side over the weekend. The tool worked great. Sorry I don't have a pic to show but it is based on one of the pictures Shogun showed a while back on "beer can" pullers. My question is, upon installation, is there a plate that covers the entire mount surface followed by a washer and nut, or is it just a washer and a nut? The picture Jeff N. shows on Brunos site next to point 11. in the installation instructions doesn't show clearly if there is a plate or not. I would assume that just a washers and nut against the through-bolt hole (or center metal sleeve) would put too much pressure in the center of the mount, and would probably rip this sleeve from the mount when turning the nut. I hope all this makes sense without a pic.